MIDEA MAP08R1CWT - Manual (Page 8)

Oper
ating
Ins
tructions
• Press the “MODE” button until the “COOL”
indicator light comes on.
• Press the ADJUST buttons “+” or “-” to
select your desired room temperature. The
temperature can be set within a range of
17°C~30°C/62°F~86°F.
• Press the “FAN SPEED” button to choose
the fan speed.
DRY operation
• Press the “MODE” button until the “DRY”
indicator light comes on.
• While in this mode, you cannot select a
fan speed or adjust the temperature. The
fan motor operates at LOW speed.
• Keep windows and doors closed for the
best dehumidifying effect.
• Do not connect the duct to a window.
FAN operation
• Press the “MODE” button until the ”FAN“
indicator light comes on.
• Press the “FAN SPEED” button to choose
the fan speed. The temperature cannot
be adjusted.
• Do not connect the duct to a window.
Operating Instructions
SLEEP operation
This feature can be activated from
the remote control ONLY. To activate
SLEEP feature, the set temperature will
increase by 1°C/2°F in 30 minutes. The set
temperature will then increase by another
1°C/2°F after an additional 30 minutes.
This new temperature will be maintained
for 7 hours before it returns to the
originally selected temperature. This ends
the Sleep mode and the unit will continue
to operate as originally programmed.
NOTE
This feature is not available in FAN or
DRY mode.
Other Features
NOTE
This feature can be activated from
the remote control ONLY. The remote
control serves as a remote thermostat
allowing for the precise temperature
control at its location.
FOLLOW ME/TEMP SENSING
Feature (optional)
To activate the Follow Me/Temp Sensing
feature, point the remote control towards
the unit and press the Follow Me/Temp
Sensing button. The remote display is actual
temperature at its location.
The remote
control will send this signal to the air
conditioner every 3 minutes until the Follow
Me/Temp Sensing button is pressed again.
If the unit does not receive the Follow Me/
Temp Sensing signal for 7 minutes, the unit
will beep to indicate the Follow Me/Temp
Sensing mode has ended.
Constant Fan button In cooling or Dry
mode, press the button for 3 seconds to
turn on or off the constant fan function.
When the function is turned on, the
constant fan light will illuminate,
identifying the fan continuous run for
cooling. When the function is turned off,
the constant fan light will go out,
identifying the fan cycle run with
compressor stop.
AUTO-RESTART
If the unit breaks off unexpectedly due
to the power cut, it will restart with the
previous function setting automatically
when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING
OPERATION
After the unit has stopped, it cannot be
restarted until 3 minutes have elapsed.
This is to protect the unit. Operation will
automatically start after 3 minutes.
AIRFLOW DIRECTION ADJUSTMENT
Adjust the air flow direction manually:
- The louver can be set to the desired
position manually.
- Do not place any heavy objects or
other loads on the louver, doing so will
cause damage to the unit.
- Keep the louver fully opened during
operation.
Page 8
CONSTANT FAN(Press 3s)
COOL operation