MIDEA MAP08R1CWT - Manual (Page 25)

Oper
ating
Ins
tructions
(W
ith R
e
m
ot
e
)
Advanced Fu
n
ctions
SHORTCUT Function
Note:
ON/OF F
T E MP
SHORT
CUT
TIMER
ON
TIMER
OFF
MODE
FAN
LED SLEEP FOLLOW
ME
SLEEP Function
The SLEEP function is used to decrease
energy use while you sleep (and don’t need
the same temperature settings to stay
comfortable). This function can only be
activated via remote control.
The FOLLOW ME function enables the
remote control to measure the
temperature at its current location.
When using AUTO, COOL, or HEAT
functions, measuring ambient
temperature from the remote control
(instead of from the indoor unit itself)
will enable the air conditioner to
optimize the temperature around you
and ensure maximum comfort.
1. Press FOLLOW ME button to activate
function. The remote control will send
temperature signal to the unit every
three minutes.
2. Press FOLLOW ME button again to
turn off this function.
Used to restore the current settings or resume
previous settings.
Push this button when remote control is on,
the system will automatically revert back to the
previous settings including operating mode,
setting temperature, fan speed level and sleep
feature (if activated).
By pressing for more than 2 seconds, the
system will automatically restore the current
operation settings including operating mode,
setting temperature, fan speed level and sleep
feature (if activated.
The SLEEP function is not
available in FAN or DRY mode.
FOLLOW ME Function
NOTES
• Button configuration shown in illustrations is based on a typical model and may
be slightly different from the actual one you purchased. In this case, please refer
to your purchased remote control.
• All the functions described can also be accomplished by using the unit’s control
panel. If the unit is without this feature, there will be no corresponding operation
when pressing the relevant button on the remote control .
Page 25