Xiaomi Robot Vacuum S10 - Manual (Page 10)

09
How to Use
1. Take out the 2-in-1 dust compartment with water tank, open the plug,
fill with clean water, and then refasten the plug. Install the 2-in-1 dust
compartment with water tank onto the robot vacuum in the direction
indicated in the figure, and make sure that the clip is firmly clasped.
2. Before using the vacuuming & mopping function, dampen the mop pad
and wring it out and then install it onto the mop pad holder. Slide the
the direction indicated in the figure until it clicks into place.
CAUTIONS:
Please remove the 2-in-1 dust compartment with water tank before adding water.
Do not add liquids such as hot water, detergent, or disinfectant to prevent
damaging the robot vacuum.
Due to production testing, the 2-in-1 dust compartment with water tank may have
water stains, which is normal.
Clip Plug
It is properly installed
when you hear a "click".
Open the plug and
add water.
If only vacuuming function is needed, please remove
the mop pad holder.
Clips
Press the clips and pull
the mop pad holder out.
Start Vacuuming & Mopping
CAUTIONS:
dry the mop pad to prevent odor and mildew.
When the robot vacuum is running, please set up virtual walls or restricted areas
for carpeted areas in your home to avoid the robot vacuum from becoming
entangled in the carpet.