Roland CUBE Street EX Battery-Powered Stereo Amplifier - Manual (Page 5)

5
Nederlands
Por
tuguês
Español
Italiano
Français
Deutsch
English
FS-5U U
Connections
Top panel
About combo jacks
You can connect either XLR
plugs or phone plugs to the
combo jacks.
About plugs in figures
XLR
1/4” phone
Stereo 1/4” phone
4-pole miniature phone
Setting of the switches
To prevent the inadvertent disruption of power
to your unit (should the plug be pulled out
accidentally), and to avoid applying undue stress
to the DC IN jack, anchor the power cord using
the cord hook, as shown in the illustration.
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
* When connection cables with resistors are used, the volume level of equipment connected to the inputs (AUDIO IN) may be low. If this happens, use connection cables
that do not contain resistors.
iPhone, iPad, etc
Rear panel
Setting of the switches
This setting sets the [LINE OUT/STEREO LINK] switch to
“LINE OUT.” Refer to “Connecting Two Units to Increase
the Output (STEREO LINK)” (p. 10), if you set this switch to
“STEREO LINK.”
Acoustic feedback could be produced
depending on the location of microphones
relative to speakers. This can be remedied by:
• Changing the orientation of the
microphone(s).
• Relocating microphone(s) at a greater
distance from speakers.
• Lowering volume levels.
(Included)