Samson HT6 Wireless Handheld Microphone Transmitter (Channel 11) - Manual (Page 13)

ENGLISH
ESP
AÑOL
IT
ALIANO
FRANÇAIS
DEUTSCHE
Issue Solutions
No Audio
Turn on the HT6 transmitter using the Power ON/OFF switch.
Ensure the HT6 transmitter’s batteries are installed correctly.
Check that the HT6 Audio ON/OFF switch is in the ON position.
Confirm that the SR466 adaptor is correctly connected and
plugged into an electrical outlet.
Turn on the SR466 receiver.
Make sure the SR466 output and audio input connections are
securely connected.
Ensure that the SR466 receiver and HT6 transmitters are in line of
sight with one another.
Check the receiver and audio input device level controls.
Distorted Audio
Check the receiver output level and audio input device level.
Check the HT6’s batteries and replace if low.
Another transmitter may be broadcasting on the same channel.
Turn off transmitter that may be causing interference.
Audio Dropout
The transmitter may be too far away from the receiver. Move
closer to the receiver, or reposition the antennas.
Remove or avoid sources that may cause RF interference, such
as cell phones, cordless phones, lighting equipment, computers,
metal structures, etc.
Transmitters and Receiver
on Different Channels
Contact your Samson reseller or distributor for assistance.
Troubleshooting
13 Stage v466: Quad Vocal Wireless System