Samson HT6 Wireless Handheld Microphone Transmitter (Channel 11) - Manual (Page 8)

1. Audio ON/OFF Switch - When set to the ON position, audio signal
is transmitted. When set to the OFF position, the audio signal is
muted. Note that moving this switch to the OFF position does not
turn off the transmitter power - it is simply a way to temporarily
mute the transmission of audio signal. When not in use for extended
periods, the transmitter power should be turned off by using the
power ON/OFF switch (see #2 below).
2. Power ON/OFF Switch - Use this switch to turn the HT6 on or off (to
conserve battery power, be sure to leave it off when not in use).
Be sure to mute the audio signal at your external mixer or amplifier
before turning transmitter power on or off, or an audible pop may
result.
3. Power Indicator - LED lights green when the transmitter is powered
on.
4. Battery Compartment - Insert a standard 9-volt alkaline battery
here. Be sure to observe the plus and minus polarity markings when
installing the battery. We recommend the Duracell MN 1604 type
battery for use with this device. Although rechargeable Ni-Cad
batteries can be used, they do not supply adequate current for more
than four hours.
WARNING: Do not insert the battery backwards; doing so can cause
severe damage to the HT6 and will void your warranty.
5. Channel Marking - Printed number corresponding to the appro-
priate channel on the SR466 receiver.
HT6 Transmitter Controls and Features
1
3
4
5
2
1
3
4
5
2
8