Samson Go Mic USB Microphone for Mac and Windows Computers (Silver) - Manual (Page 8)

6
Installing the Go Mic
Installing the Go Mic is a simple procedure
that takes just a few minutes. Since the Go
Mic is USB compliant, you can use either
a MAC or PC, connect the included USB
cable and plug and play. You will be able
to control your Go Mic using the standard
audio interface controls in the MAC or
Windows operating system. You will find
detailed instructions on setting up with
MAC OS and Windows in the following
sections of this manual.
Getting Started with Windows XP
1. The first time you plug the Go Mic into
a USB port, Windows will install the
universal drivers for that port. A balloon
tip will pop up, telling you it has “Found
new Hardware” (figure 1).
2. When it is finished installing the drivers,
it will say “Your new hardware is installed
and ready to use” (figure 2).
Note: This balloon will not pop up again for
the same USB port.
Figure 1
Figure 2
Figure 3