Samson Stage 200 Dual-Channel Handheld VHF Wireless System (Channel A) - Manual (Page 14)

14
Issue Solutions
No Audio
Turn on the VH200 transmitter using the Power/Mutr switch.
Ensure the VH200 transmitter’s batteries are installed correctly.
Confirm that the SR200 adaptor is correctly connected and
plugged into an electrical outlet.
Turn on the SR200 receiver.
Make sure the SR200 output and audio input connections
are securely connected.
Ensure that the SR200 receiver and VH200 transmitters are
in line of sight with one another.
Check the receiver and audio input device level controls.
Distorted Audio
Check the receiver output level and audio input device level.
Check the VH200’s batteries and replace if low.
Another transmitter may be broadcasting on the same channel.
Turn off transmitter that may be causing interference.
Audio Dropout
The transmitter may be too far away from the receiver. Move
closer to the receiver, or reposition the antennas.
Remove any sources that may cause RF interference, such as
cell phones, cordless phones, lighting equipment, computers,
etc.
Transmitters and
Receiver on Different
Channels Contact your Samson reseller or distributor for assistance.
Troubleshooting