Sony ZRD-B12A Micro LED Video Wall Modular Display - Manual (Page 20)

20
[3D Sync Signal Delay]: Use the slider or
buttons to adjust the phase (when 3D video
is not displayed properly). Moving the slider
also changes the number value. Clicking
[Reset] restores the default value.
Inversion and phase adjustments can be
configured for both mixed L/R and separated L/
R. The settings are reflected in the picture
immediately after they are configured.
Displaying the test
pattern for each Display
Cabinet
Display Control Software allows you to display
the test pattern for the specified Display Cabinet.
• The test pattern for each Display Cabinet can
be displayed in Display Control Software
v01.01.00 or later.
• Test patterns cannot be displayed if the
primary controller is not set with Display
Control Software or if the primary controller is
in a state other than on.
Select [Function] in the main Display Control
Software screen, then select [Cabinet Test
Pattern].
The cabinet test pattern display settings screen is
displayed.
[Cabinet Test Pattern]: From the drop-down list,
select the test pattern to display on the
display cabinet.
[Red]/[Green]/[Blue]/[White]/[Custom1] -
[Custom4] can be selected.
RGB can be set individually for [Custom1] to
[Custom4] to change the pattern and display
color.
Note
Caution
Note