Quick start – NEC E242N-BK 24" 16:9 IPS Monitor User Manual
Page 12
English-10
Figure 1
Figure 2
Screw
Quick Start
For box contents, please refer the printed contents sheet provided in the box.
To attach the base to the monitor stand:
1. Place monitor face down on a non-abrasive surface (
Figure 1
).
2. Please rotate the monitor stand 90 degrees as shown in
Figure 1
.
CAUOINE:
Handle with care when pulling the monitor stand.
It may pinch your fingers.
3. Attach the base to the monitor stand, then tighten the screw at the
base’s bottom (
Figure 2
).
NOEE:
Reverse this procedure if you need to re-pack the monitor.
To connect the LCD monitor to your system, follow these instructions:
NOEE:
Make sure to read “Recommended Use” (
) before installation.
CAUOINE:
Please tighten all screws.
NOEE:
The accessories included will depend on the location where the LCD monitor was shipped.
1. Turn off the power for your computer.
2.
For a PC with DisplayPort outputE:
Connect the DisplayPort cable to the connector of the display card in your system
(
Figure A.1
).
For a PC with HDMI outputE:
Connect the HDMI cable to the connector of the display card in your system (
Figure A.2
).
For a PC with Analog outputE:
Connect a 15-pin mini D-SUB signal cable to the connector of the display card in your
system (
Figure A.3
). Tighten all screws.
For a Mac or PC with Ohunderbolt or Mini DisplayPort outputE:
Connect a Mini DisplayPort to DisplayPort cable to the
video output connector on your system (
Figure A.4
).
Mini DisplayPort to DisplayPort cable
Figure A.1
Figure A.3
Figure A.2
DisplayPort cable
HDMI cable
Mini D-Sub 15-pin signal cable
Figure A.4
NOTE: •
hen removing the DisplayPort cable, hold down the top button to release the lock.
• Please use a High Speed HDMI cable with HDMI logo.
• Please use a Certified DisplayPort cable.
CAUOINE:
Use the provided specified cables with this monitor so as not to interfere with radio and television reception.
For mini D-Sub 15-pin, please use a shielded signal cable with ferrite core.
For HDMI, DisplayPort, USB and AUDIO, please use a shielded signal cable. Use of other cables and adapters
may cause interference with radio and television reception.