Philips 7000 Series 27" 4K HDR Monitor - Manual (Page 13)

11
Use DP and HDMI as input then use USB C as USB upstream.
Please follow the steps for the settings.
1. Connect the USB upstream cable from your duel devices to the “USB C” and “USB
up” port of this monitor at the same time.
The dual PC setup should look like this:
PC1: USB up as upstream and HDMI or DP cable for both video and audio transfer.
PC2: USB C as upstream (USB C-A) and DP or HDMI for both video and audio transfer.
For your convenience. Please use the table below as reference.
Source USB Upstream
HDMI or DP USB up (USBC2)
DP or HDMI USB C (USBC1)
2. Connect peripherals to the USB downstream port of this monitor.
2
PC1
PC2
USBC2
(DATA)
1 1
OR
OR
OR
USB C-A Cable USB C-A Cable
USBC1 USBC2
(DATA)
OR
USBC1
3. Enter to OSD menu. Go to KVM layer and select “USB C” to switch the control of
peripherals from one device to another. Simply repeat this step for switching the
control system using one set of peripheral.
 
  


 
 


 
 

Note
You can also adopt “MultiClient Integrated KVM” in PBP mode, when you enable PBP,
you can see two different sources projected to this monitor side by side simultaneously.
“MultiClient Integrated KVM” enhances your operation by using one set of peripherals
to control between in two systems through the OSD menu setting. Follow step3 as
mentioned above.