Rf standing pilot lighting instructions, For your safety read before lighting, Lighting instructions to turn off gas to appliance – Empire Comfort Systems DVP48FP3 EN User Manual

Page 61

Advertising
background image

21759-6-0608

Page 61

1. STOP! Read the safety information above.

2. Turn off all electric power to the appliance (if

applicable).

3. Lower louver front assembly.

4. Push in gas control knob slightly and turn clockwise

to "OFF".

NOTE: Knob cannot be

turned from "PILOT"

to "OFF" unless knob

is pushed in slightly. Do

not force.

5. Wait ten (10) minutes to

clear out any gas. Then

smell for gas, including near the floor. If you smell gas,

STOP! Follow "B" in the safety information above. If you

do not smell gas, go to the

next step.

6. Find pilot - follow metal

tube from gas control.

The pilot is behind the

middle log on the right

side.

7. Turn gas control knob counterclockwise

to

"PILOT".

8. Push in control knob all the way and hold in. Immediately

light the pilot with the Piezo Pilot ignitor or use a match.

Continue to hold the control knob in until LED blinks (one

brief blink every two seconds). Holding time is about one

(1) minute after the pilot is lit. Release knob, and it will

pop back up. Pilot should remain lit. If it goes out, repeat

steps 4 through 8.
If knob does not pop up when released, stop and

immediately call a qualified service technician or gas

supplier.
If the pilot will not stay lit after several tries, turn the gas

control knob to "OFF" and call your service technician

or gas supplier.

9. Turn gas control knob counterclockwise

to

"ON".

10. Close louver front assembly.

11. Turn on all electric power to the appliance (if

applicable).

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR

EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR

LOSS OF LIFE.

A. This appliance has a pilot which must be lighted by

hand. When lighting the pilot, follow these instructions

exactly.

B. BEFORE LIGHTING, smell around the appliance area

for gas. Be sure to smell next to the floor because some

gas in heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch.

• Do not use any phone in your building.

• Immediately call your gas supplier from a

neighbor's phone. Follow the gas supplier's

instructions. If you can not reach your gas

supplier, call the fire department.

C. Use only your hand to push in or turn the gas control

knob. Never use tools. If the knob will not push in or turn

by hand, don't try to repair it, call a qualified service

technician. Force or attempted repair may result in a fire

or explosion.

D. Do not use this appliance if any part has been under water.

Immediately call a qualified service technician to inspect

the appliance and to replace any part of the control system

and any gas control which has been under water.

LIGHTING INSTRUCTIONS

TO TURN OFF GAS TO APPLIANCE

1. Turn off all electric power to the appliance if service is to

be performed (if applicable).

2. Lower louver front assembly.

3. Push in gas control knob slightly and turn clockwise

to "OFF". Do not force.

4. Close louver front assembly.

RF STANDING PILOT LIGHTING INSTRUCTIONS

Advertising
This manual is related to the following products: