Kodak PIXPRO SP360 4K Action Camera Dual Pro Pack - Manual (Page 12)

11
Mounting / Removing Lens Ring and Lens Cover
Removing lens cover:
Turn the lens cover according to the illustrated direction until it separates from the
SP360 4K.
Mounting lens cover
Turn and firmly tighten the lens cover according to the illustrated direction.
Lens ring and lens cover cannot be used at the same time.
The lens cover protects the lens from being damaged (dustproof, shockproof and splash proof). Using the lens cover when taking a photo/shooting a video will not
influence the image/video quality.
Before mounting the lens cover, make sure the lens surface is clean and dry. Always use a clean, lint-free dry cloth to clean the lens before shooting or recording so it
will not affect the photo or video quality.
When the SP360 4K is exposed to extreme temperature differences condensation may form inside of the lens cover. If this happens, remove the lens cover, clean it
with a soft, dry, lint-free cloth, and then reinstall the lens cover.
If the SP360 4K will not be used for a period of time, always put the protective cover on it (as shown in the figure).
The processes of mounting/removing lens ring and lens cover are the same, with lens cover as an example as below: