Elo TouchSystems 5503L 55" Class Full HD IR Interactive Commercial Display - Manual (Page 23)

User Manual – IDS ET5503L UM600482 Rev. B, page 23 of 37
Audio
Audio can be output from the following locations:
1.
From the IDS Display speakers via the video channel
2. The Line Out port on the IDS IO ports
3. From the computers Line Out port (If an Elo Computer Module is installed)
See the “Audio” OSD parameter for details.
Note: When headphone is plugged into the headphone output jack, the internal speakers turn off and audio is played over the
headphone.
Volume and muting of the speaker and headphone outputs are controlled by the OSD.
Controlling the IDS Display remotely
The IDS Display allows remote access from a host application. This is done using either the VESA Display Data Channel Command Interface
(DDC/CI) or the Multiple Display Control command sets. Users can communicate with the monitor through either of these protocols. The host
application can send a variety of different commands which will be executed on the IDS Display. For detailed information regarding the
command set, refer to the application note available
here .
CEC Functionality (Consumer Electronic Control)
The IDS Display is equipped with CEC capability. If a host device (with CEC built in) is connected to the monitor through HDMI, the monitor
can be turned on by only turning the host device on.
Real Time Clock (RTC) Functionality
This IDS Display has real time clock functionality. In the OSD menu, there is a sub-menu called RTC Settings.
To utilize the RTC functionality:
The user must set up the Time setting for their specific time zone.
When the On/Off Schedule is Enabled, the user can choose when to leave the monitor on and when it should be off. Individual or