Panasonic AV-HS6000 2 M/E Live Switcher Main Frame & Control Panel (Dual Redundant Power Supplies) User Manual
Page 150
– 150 –
Chapter 8 System Menu — Setting the Main Frame AV‑HS60U1/AV‑HS60U2
[On]
Adds to the DSK preview output.
[Off]
Does not add to the DSK preview output.
4
Select an item in [DSK Base] in the [DSK PVW Base] column.
f
Select the background of the preview output of DSK (DSKPVW1, DSKPVW2, DSK1PVW to DSK4PVW).
[PGM]
Uses the PGM output of ME in the last line.
However, for the DSKPVW output against the DSKPGM that is not assigned to [DSK1] to [DSK4] of the [Config] column
will be the PVW output of ME in the last line.
[PST]
Uses the PVW output of ME in the last line.
This cannot be selected when the [Combine] item in the [DSK PVW] column is set to [Off].
5
Select an item in [DSK1CLN] to [DSK4CLN] in the [DSKPVW ASSIGN] column.
f
Select the signal to be assigned to DSK1CLN to DSK4CLN.
[DSK1CLN] ‑ [DSK4CLN]
Assigns the clean signal for corresponding DSK.
[DSK1PVW] ‑ [DSK4PVW]
Assigns the individual preview signal for corresponding DSK.
6
Select an item in [DSKPVW2] in the [DSKPVW ASSIGN] column.
f
Select the signal to be assigned to DSKPVW2.
[DSKPVW2]
Assigns the signal for preview of DSKPGM2.
[DSK1PVW] ‑ [DSK4PVW]
Assigns the individual preview signal for corresponding DSK.
[DSKPST]
Assigns the PVW output for ME of the last line.
Setting the SEL KEYPVW output
The preview for the corresponding key is output to the SEL KEYPVW output when the <KEY1> to <KEY4>, and <DSK1> to <DSK4> buttons in the KEY
operation area of ME are pressed.
The chroma key adjustment preview screen is displayed when the key type of the corresponding key is [Chroma].
1
Select the <SYS> button
→
[MAIN FRAME]
→
[Sel KeyPVW] tab.
2
Select an item in the [Panel Ctrl] column in the [Mode] column.
[On]
The preview of the corresponding key is output by pressing the <KEY1> to <KEY4> or the <DSK1> to <DSK4> buttons
in the KEY operation section of each ME.
[Off]
The SEL KEYPVW output will not change when the <KEY1> to <KEY4> or the <DSK1> to <DSK4> buttons in the KEY
operation section of each ME is pressed.
3
Select an item in [Key1 Enable] to [Key4 Enable] in the [ME1]/[ME2]/[DSK] column.
[On]
Outputs the image where the key is combined when the button of the corresponding key is pressed.
[Off]
Outputs the image where the key is not combined when the button of the corresponding key is pressed.