Enviro C-10365 - Manual (Page 23)

23
Secondary Installation
I
NSTALLATION OF
L
OG
S
ET AND
E
MBERS
:
CAUTION: Use only the type of ember
material supplied with this appliance.
Due to the irregular size of the ember
material there may be more than
required. The use of other foreign
materials on the burners may create
dangerous conditions.
If over time, through cleaning and
servicing, these embers require
replacement, contact the nearest
ENVIRO dealer for replacement
embers.
1. The embers can be place before
or after the logs are placed. A bag of
ceramic fiber embers and rock wool
embers is provided gently remove the
ember material from the plastic bag.
Spread a layer loosely in a random
manner across the burner tray. Do not
allow any embers to rest against pilot
assembly. (See Figure 32 or 35 for
proper ember placement.)
DO NOT pack this ember material as
this could create an unsafe condition,
leave embers loose
2. Carefully remove logs from box.
Check to ensure there is no damage.
It is very important to install all logs
in their proper position to insure safe,
optimum operating conditions.
3. Place the log set into the firebox.
Locate each log by seating it down onto
the burner tray support pins. Follow
Figures 31 to 35 proper log placement.
Figure 31: Step 1 of Log Placement.
Figure 32: Step 2 of Log Placement.
Figure 33: Step 3 of Log Placement.
The placement of the logs is not arbitrary. If they are positioned incorrectly, the flames can be “pinched” and will
not burn correctly. The burner come with five (5) locator pins, and the rear log has one (1) ledge, which make
alignment easier. Using the pictures provided, carefully set the logs in place.
NOTE: The logs are fragile and should be handled gently.