7 configuration, 1 unit settings, 1 rear panel settings – Bosch PLE-1ME240-US Plena Mixer Amplifier User Manual

Page 20: 2 pin settings and labeling, Configuration, Unit settings, S and labeling, Section 7.1 unit settings, 7configuration

Advertising
background image

20

en | Configuration

Plena Mixer Amplifier

PLE-1MExx0-xx | V1.0 | 2011.04

Installation and Operation manual

Bosch Security Systems B.V.

7

Configuration

7.1

Unit settings

7.1.1

Rear panel settings

The unit can be quickly set-up for operation by setting the following controls at the rear of the

unit:

DIP switches

7.1.2

Pin settings and labeling

Users can create custom labels for the: microphone/line inputs, description of the music

source. These labels can be attached to the mixer amplifier at position number 2 (see

Figure 3.1

). Colored pins can also be inserted at various positions around the dial controls to

indicate the favorite settings for a particular application.

The pins are engineered in such a way that they cannot be taken out by hand. This is to

prevent tampering. The pins are intended to be inserted once, during installation of the unit.

The silver pins should be used to indicate the preferred settings of the unit. The red pins can

optionally be used to indicate the maximum setting of a knob.

If these settings have to be changed, use a pair of soft-tipped pliers to carefully remove the

pins. If you do not have a pair of soft-tipped pliers, you can use ordinary pliers instead, but

first place some plastic tape on the tips of the pliers to prevent damaging the front of the unit.

To remove the clear plastic covers in front of the labels:

1.

Carefully insert a small screwdriver into the cut-out at the bottom of the plastic cover.

2.

Gently lift the cover, and bend it in the middle. Take care not to force the cover or the

front panel.

To reattach the plastic covers with paper labels:

1.

Insert the paper label into the holder at the front of the unit.

2.

Pick up the cover, and then bend it slightly in the middle by hand.

3.

Fit the cover into the slot at the front of the unit, and then gently release the cover,

making sure that the paper label stays in place.

Advertising