Explore Scientific Radio-Controlled Projection Clock with External Weather Sensor (Silver) - Manual (Page 37)

IT
DE
EN
37
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC recep-
tion is initiated. To manually start RCC reception
press the [
] button.
2. The receiving process duration is 2-10 minutes. If
the signal is weak, it could take up to 24 hours to
receive a valid signal.
3. During receiving process, the RCC signal symbol
shows: [ ].
4. If the RCC receiving process is successful, a com-
pleted RCC symbol [ ] will be shown in the display
and the date and time will be set automatically. If it
fails within 7 minutes, RCC setting will quit automati-
cally. If that happens, press [
] button to re-initi-
ate RCC receiving.
5.To stop RCC reception, press and hold the
[ ] button.
6. If the device is still not receiving the signal, please
proceed to set the time manually.
NOTE: When using a power adapter, please increase
the separation of the main unit and the power adapter
to avoid interference of RCC signal receiving.
SET THE CLOCK MANUALLY
1. Press and hold [ ] button to enter time and date
setting.
2. The setting parameter will flash.
3. Press [+] button once, the figure will increase 1 unit
(when setting minute, second will reset to 0). Press and
hold the [+] button, the figures will increase rapidly.
4. Press [–] button once, the figure will decrease 1
unit (when setting minute, second will reset to 0).
Press and hold the [–] button, the figures will de-
crease rapidly.
5. Press [ ] button to confirm setting and enter to
next parameter.
6. Sequence of setting: Zone  12/24h format  Hour
 Minute  Year  Calendar format (month-day/
day-month)  Month  Date  Temperature unit
(°C/°F)  Weekday Language  Exit
7. If there is no action in 20 seconds or if you press and