Epson QX-10 - Manual (Page 36)

Powering Up
Before you power up your QX-10, check to see that the power
switch is OFF. Then plug the power cable into the wall outlet and
turn the main unit around so that the front faces you.
Now, unless your option card manual contains special instruc-
tions, you’re ready to power up your QX-10.
Caution: Always wait at least 5 seconds after switching OFF power
before switching power back ON. Failure to wait can
damage your computer.
Removing Option Cards
Follow the earlier steps for powering down and removing the
cover. Then detach any cables connected to the option card and
slide the card straight up and out of the notched guides.
Be sure to rewrap the card (preferably with the original pack-
ing materials) and place it inside the carton for safe storage.
Replace the cover as described previously. Then follow the pro-
cedure for powering up and inform the QX-10 of what you’ve just
removed, by using the appropriate procedure for your operating
system, as described in your option card manual.
34