Epson QX-10 - Manual (Page 7)

Getting Hooked Up
Now that all the boxes are unpacked, it’s time to put the parts
together into a working system. Start with the main unit. That’s
the one that looks like this:
Place it on the flat surface with the front facing you, as shown.
Remove the disk drive protector sheets from the two disk drives
(marked A and B) by pressing the button labelled PUSH located
at the left side of each drive. When you push it, the button pops
out, as does the edge of the protector sheet. Carefully pull out
both sheets and save them along with the other shipping materials.
Now turn the main unit around so that the back is facing you,
like so:
M O N I T O R P O R T - , DIP SWITCHES
LIGHT PEN PORT S P E A K E R C O N T R O L
POP-OUT
POWER CORD
OUTLET
PRINTER R S - 2 3 2 C OPTION CARD
PORT PORT ACCESS SLOTS
- - - -
To connect the components of the QX-10, you’ll use two of the
outlets on the back of the main unit. The power cord connects
to the large rectangular outlet on the left side, labelled CAUTION:
DISCONNECT POWER BEFORE SERVICING. The round monitor
outlet is where the monitor cable attaches to the main unit.
3