Lenovo Legion Go Handheld Gaming System - Manual (Page 31)

Chapter 4. Firmware setup utility
Your console includes a flash ROM (read-only memory) chip on the system board. It contains code to start
up the console. The ROM chip and the stored code are referred to as the console’s firmware. Firmware plays
a key role in the operation of the console. When you turn on the console, the firmware checks and initiates
the console’s hardware devices. It also checks the boot device for completeness and security, before
executing the code to start up the operating system.
A Lenovo console usually provides a setup utility that allows you to change some firmware settings. You can
use Windows advanced startup to restart your console and open the firmware setup utility.
For normal use, you will rarely use the firmware setup utility.
Use Windows advanced startup to open the firmware setup utility
From Windows operating system, you can use advanced startup to restart your console and open the
firmware setup utility.
Step 1. Select Settings ➙ System ➙ Recovery .
Step 2. Under Advanced startup , select Restart now .
Step 3. Select Troubleshoot on the Choose an option page.
Step 4. Select Advanced options on the Troubleshoot page.
Step 5. Select UEFI Firmware Settings on the Advanced options page.
Step 6. Click Restart .
Your console will restart to open the firmware setup utility.
Open the firmware setup utility from the Novo Button Menu
The console provides a shortcut to open the firmware setup utility.
Make sure your tablet is powered off.
Step 1. While holding down , press the power button until the Novo Button Menu is displayed.
Step 2. Select BIOS Setup from the Menu.
Set passwords in UEFI/BIOS setup utility
This section introduces the types of passwords that you can set in the UEFI (Unified Extensible Firmware
Interface) or BIOS (Basic Input/Output System) setup utility.
Password types
You can set various types of passwords in the UEFI/BIOS setup utility.
© Copyright Lenovo 2023 25