Epson EB-W8D - Manual (Page 69)

67
Appendix
Appendix
You can check the status of this unit using the
indicators on the top panel.
Check each condition in the following table and follow
the steps to remedy the problem.
* If all indicators are not lit, the power cable is not
connected correctly or the unit is not powered.
Troubleshooting
When the or indicators flash orange Warning
: lit : flashing : off
High Temperature
alarm
You can continue
projecting in this state.
Projection stops
automatically if
subsequent high
temperatures are
registered.
Check the 2 items listed.
• Move this unit away from
the wall at least 20 cm.
• Clean the air filter.
s
p. 72
If there is no improvement when
you press and switch the
power on, discontinue use and
disconnect the power cable from
the electrical outlet. Contact your
local dealer or the nearest address
provided in the Inquiries.
s
p. 86
Lamp replacement notification
It is time to replace the lamp. Replace the lamp with a new one as soon as possible. Do not continue to
use the lamp in this state, otherwise it may explode.
s
p. 75
Reading the indicators
Orange
Red
Orange
Green