Epson EB-W8D - Manual (Page 70)

68
When lights on red Error
: lit : flashing : off
Internal failure
Wait for approximately 1 minute and 30 seconds.
Then, disconnect and reconnect the power cable.
If the indicator status does not change when
is pressed and the power turned on...
Fan related error/Sensor error
High temperature error
(overheating)
The lamp turns off automatically and
projection stops. Wait for approximately 5
minutes. When the Power indicator color
changes to orange, check for the 3 points
shown at right.
• Move this unit away
from the wall by at
least 20 cm.
• Clean the air filter.
s
p. 72
• When using this unit
at high altitudes, that
is 1500 m or more
above sea level, set
“High Altitude Mode”
to “On”.
s
p. 63
If the indicator status
does not change when
is pressed and the
power turned on...
Lamp error/Lamp failure/Lamp cuts out
Wait for approximately 1 minute and 30 seconds, and check for a blown lamp.
s
p. 75
Clean the air filter and the air intake vent.
s
p. 72
The lamp is not broken
Reinsert the lamp then turn on the main
power switch on the main unit. If the condition is not
fixed once the lamp is
re-inserted
The lamp is broken Contact your dealer for further advice.
s
p. 86
When using this unit at high altitudes, that is 1500 m or more above sea level, set “High Altitude Mode”
to “On”.
s
p. 63
Auto Iris Error
Power Err. (Ballast)
Red
Red
Red
Disconnect the power cable from the electrical
outlet and contact your dealer. If the error continues
Wait for approximately 1 minute and 30
seconds. Then, disconnect the power cable
from the electrical outlet and contact your local
dealer or the nearest address provided in the
Inquiries.
s
p. 86
Red
Red
Red
Red
Red
Red
Red
Red
Red