Waves eMotion LV1 64-Channel Mixer with Axis One Custom Computer - Manual (Page 146)

141
Waves eMotion LV1 User Guide | Chapte r 4: Mixer Window
Window
Channel Input
Channels 1–64 are input channels that patch to I/O devices, including shared devices. The number of
inputs available for patching is determined by the various devices assigned to the mixer.
• Drop-down menus at the top of each channel strip show available I/O device channels.
• An I/O channel can patch to several mixer input channels. Unavailable I/O channels are grayed out.
• Once an I/O channel is selected, its name appears in the channel input name box just below
the channel name.
• To change the input mode of the channel, select “Flip to Mono” or “Flip to Stereo.” When
converting a stereo track to mono, the top (left) channel will become the mono input. When
flipping from mono to stereo, only the left channel is patched.
M
ODE
C
ONTROLS
S
ECTION
This section is reserved for the Layer Mode controls. Each Layer Mode has its own graphic interface. Please refer to the section Layer
Modes later in this chapter.
C
HANNEL
P
ARAMETERS
S
ECTION
The bottom section of a channel strip is the same for all input and buss channels.
P AN /B ALANCE /R OTATION K NOB
Pans mono channels between left and right when sent to a stereo buss. Controls the balance of a stereo signal or moves the
image wi thout changing its internal balance. This multifunction controller is discussed in the next section.
C HANNEL M UTE
A user-selected Mute for a specific channel will be solid red. A Mute activated by mute group, a DCA fader, or solo will flash
red.
When a mute button on a channel is flashing, click it again unmute it.
• Click one more time to keep the channel muted even if the mute group is deactivated.
• Click a third time to return to mute group behavior.
In the Solo-in-Place mode, the mute indicators on all channels ( except the soloed channel) will flash red until solo is
cancelled.