Onkyo TX-NR7100 9.2-Channel THX-Certified Network AV Receiver - Manual (Page 136)

136
Setup Setup
5. Hardware
„
6. Works with SONOS
Change the settings to connect with the Sonos Connect.
(SONOS-1/SONOS-2/SONOS-3)
‰ Input Selector (Default Value: Off)
Select the input selector to which the Sonos Connect is connected.
• Selecting "Off" disables the interlock function with Sonos.
‰ Connected Device (Default Value: -)
Displays the Sonos Connect connected to the same network as the network of
this unit. Press the ENTER button to select the connected Sonos Connect.
• Products (e.g. Play:3 unequipped with an output terminal) other than the
Sonos Connect are also displayed in the device list and selectable. In
that case, when playback on the Sonos side starts, the input is switched,
however, audio is not output. Select the room name of the connected Sonos
Connect.
• Up to 32 devices can be displayed on the Sonos product list screen. If you
cannot find the Sonos Connect to be interlocked, return to the previous
screen, turn off the product you do not want to interlock, and try again.
• To use this function, set "Input Selector" beforehand.
‰ Output Zone (Default Value: Main)
Select the zone where you want to listen to the music.
• To use this function, set "Input Selector" beforehand.
Main Outputs audio only to the main room (where this unit is
located).
Zone 2 Outputs audio only to the separate room (ZONE 2).
Main/Zone 2 Outputs audio to both the main room and separate room
(ZONE 2).
Zone 3 Outputs audio only to the separate room (ZONE 3).
Main/Zone 3 Outputs audio to both the main room and separate room
(ZONE 3).
Zone 2/Zone 3 Outputs audio to both the separate rooms (ZONE 2 and ZONE
3).
Main/Zone 2/
Zone 3
Outputs audio to the main room and both separate rooms
(ZONE 2 and ZONE 3).
‰ Preset Volume (Default Value: Main=Last / Zone 2=Last /Zone
3=Last)
You can set the volume beforehand for playing back the Sonos Connect. You
can set volumes for the main room (where this unit is located) and separate
room (ZONE 2 or ZONE 3) respectively. Select a value from "Last" (Volume
level before entering standby mode), "Min", "0.5" to "99.5" and "Max".
• To use this function, set "Input Selector" beforehand.