Miops Splash Water Drop Kit - Manual (Page 11)

camera will be triggered 100 milliseconds later than the last drop.
Trigger Mode: This parameter is used to de ne which output will be triggered after the last
drop. You can select one of the two possible modes. The modes are the “Flash” and the “Camera”. In
the “Camera” mode, it will trigger the camera after dripping the drop(s). In the "Flash" mode, it will
trigger the camera to start the long exposure before releasing the drop(s) and trigger the ash after
releasing the drop(s).
10. Example Setup:
You can nd an example setup for 2 drop water collision below. In this setup, you should put your
camera to BULB mode and trigger your ash to eliminate the shutter lag of your camera. If you don't
have a camera connection cable, you can start the long exposure manually before each shot.
1st Drop: Duration: 50ms
2nd Drop: Duration:50ms - Delay:100ms
3rd Drop: Duration:0 - Delay:0
4th Drop: Duration:0 - Delay:0
Trigger: Mode: Flash Delay:200ms
Height: 25 cm (from the water surface to the dripper)
   
Home Products  Support SHOP Blog Contact Explore 