Extron electronic IPL T S Series - Manual (Page 16)

IPL T S Series • Installation and Operation 2-4
Installation and Operation, cont’d
IPL T S2
1
R
100
CO M TX
LIN K AC T
2 R X
R TS C T S
IPL T S2
1
R
100
CO M TX
LIN K AC T
2 R X R TS
C T S
MD A SERIES DISTRIB UTION AMPLIFIE
R
®
®
Figure 2-2 — Mounting the interface on the standard shelf
Furniture or projector mounting
The following furniture and projector mount kits are available:
• PN 70-077-01 Furniture mount kit (for IPL T S1)
• PN 70-077-04 Projector mount kit (for IPL T S1)
• PN 70-212-01 Furniture mount kit (for IPL T S2, S4, S6)
• PN 70-217-04 Projector mount kit (for IPL T S2, S4, S6)
To mount an IPL T S Series device to furniture:
1 . If present, remove the rubber feet from the bottom of the IPL T S unit.
2 . Attach the furniture mounting brackets to the unit with the supplied screws.
3 . Hold the unit with the attached brackets against the underside of the
furniture. Mark the hole locations of the bracket on the mounting surface.
4. Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm) deep in the underside
of the mounting surface at the marked hole locations.
5 . Insert #8 wood screws into the four pilot holes. Tighten each screw until just
less than 1/4” (6.3 mm) of the screw head protrudes above the surface.
6 . Hang the mounting bracket over the protruding screw heads. Slide the
mounting brackets to the narrow end of the screw slots and tighten the
mounting screws.
To mount an IPL T S Series device with a projector:
1 . If present, remove the rubber feet from the bottom of the IPL T S unit.
2 . Attach the projector mounting bracket to the unit with the supplied screws.
3 . Secure the unit to the projector post with the supplied mounting bolt.