Kodak A3 Flatbed Accessory - Manual (Page 5)

2 A-61563/Part No. 7J3981October 2010
Installing the flatbed 1. Power down the scanner.
2. Attach one end of the cable to the flatbed.
3. Attach the other end of the cable to the scanner.
4. Turn on the scanner. If the flatbed is being connected for the first
time, wait for the PC to find and install the device drivers for the
flatbed. When the LED on the flatbed is green and steady, the
flatbed is ready to use.
NOTE: If you need to remove the cable from the scanner or flatbed,
turn off the scanner, then push down on the red tab to release
the cable from its position.