Indicator is lit or flashing red, Problem solving – Epson EB-825 User Manual

Page 56

Advertising
background image

If all indicators are off, check that the power cable is connected correctly and that the power is being supplied normally.
Sometimes, when the power cable is unplugged, the

t

indicator remains lit for a short period, but this is not a fault.

t

Indicator is lit or flashing red

: Lit

: Flashing:

: Off

Status

Cause

Remedy or Status

Internal Error

Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address
provided in the Support and Service Guide. s

Epson Projector Contact List

Fan Error
Sensor Error

Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address
provided in the Support and Service Guide. s

Epson Projector Contact List

High Temp Error
(overheating)

The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector
switches to standby mode, so check the following two points.
• Check that the air filter and Air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s

p.67

,

p.72

If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical
outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide. s

Epson Projector

Contact List

When using at an altitude of 1500 m or more, set High Altitude Mode to On. s

p.39

Lamp Error
Lamp Failure
Lamp Cover Open

Check the following two points.
• Take out the Lamp and check if it is cracked. s

p.69

• Clean the air filter. s

p.67

If it is not cracked

: Re-fit the Lamp and turn on the power.

If the error continues

: Replace the Lamp with a new lamp and turn on the power.

If the error continues

: Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local

dealer or the nearest address provided in the Support and Service Guide. s

Epson Projector Contact List

Problem Solving

56

Advertising
This manual is related to the following products: