Emerson Radio ES1 - Manual (Page 12)

11
OPERATING INSTRUCTIONS
SETTING THE CLOCK
When the system is connected to AC power for the first
time, the standby LED indicator on the front panel comes
on and the main display begins flashing “12:00 AM”. This is
your indication that the time on the display is incorrect and
needs to be set. To set the clock, proceed as follows:
1. Press and hold the CLOCK button on the top panel for
at least one second.
2. Adjust the hours on the display by pressing the UP
button. Each time you press the UP button, the display
will advance by one hour. If you hold the UP button,
the hours will continue to advance.
Note: Make sure you are setting the time to the correct hour
(AM or PM) by confirming that the correct AM or PM
indicator appears in the display.
3. Adjust the minutes by pressing the DOWN button.
Each time you press the DOWN button, the display
will advance by one minute. If you hold the DOWN
button, the minutes will continue to advance.
4. When the correct time appears on the display, press the
CLOCK button once more. The time display will stop
flashing and the clock will begin to run normally from
that point.
The time will always appear on the display when the power is switched off. To see the time while
you are listening to Radio or playing a CD, simply press the CLOCK button once. The display will
change from either Radio frequency or CD display to Clock display. To change back to Radio
frequency or CD display, press the CLOCK button once more.
Note: If the unit is disconnected from the AC power supply or the AC power supply is interrupted for
any reason, the clock timer settings will be lost and it will be necessary to reset the clock
when power is restored.
NOTE: INSTRUCTIONS FOR “USING THE REMOTE CONTROL” BEGIN ON PAGE 16.
CLOCK