Emerson Radio ES1 - Manual (Page 5)

4
POSITIONING THE SPEAKERS
The speakers may be positioned next to the main unit or separated as far as the wires will allow.
We recommend that you leave a gap of approximately 1/2” between the speakers and the main unit
so that vibration from the speaker does not cause the CD player to skip.
ANTENNA CONNECTION
The AM and FM antennas connect to the AM and FM terminals on the system’s back panel. They
must be hooked up in order to receive clear reception.
AM LOOP ANTENNA AND FM T-TYPE ANTENNA
Your system comes with an AM loop antenna with black wires and an FM T-type dipole antenna.
Connect the antennae to their respective terminals on the back of the unit the same way as the wire
connections from the speakers to the unit. Locate the bare ends of the wires, open the tab of the
terminal, insert the bare end of the wire and close the tab. Repeat for the other wires. After connecting
the antennas, extend them to their full length and adjust their positioning for better radio reception.
CONNECTING AUXILIARY EQUIPMENT
This system includes auxiliary input and output jacks which allow you to connect a wide range of
external components to expand the capability of the system.
LINE IN (AUX)
Use the AUX IN jacks on the back of the unit to connect an auxiliary component, such as a cassette
deck, VCR, TV, camcorder or other compatible device. To connect an auxiliary component, connect
the left and right audio output jacks from the component to the left (L) and right (R) input jacks on
the back of the unit. Note: Connection cables are not included.
(Not included) External Audio Source
AM FM