Western Digital WD 2TB 3D NAND SATA III 2.5" Internal SSD (Retail) User Manual

Page 8

Advertising
background image

M.2 2280 is single-sided for all capacities

▪ Interface to Host

SATA III 6Gb/s (rev. 3.2) compliant

Backwards compatible with SATA II 3Gb/s and SATA I 1.5Gb/s

ATA 8 command set ACS-4

NCQ support up to queue depth of 32

SMART support

▪ High Performance

5

Sequential read up to: 560 MB/s

Sequential write up to: 530 MB/s

4K random read up to: 95,000 IOPS

4K random write up to: 84,000 IOPS

▪ Low Power Consumption

6

Maximum active power: less than or equal to 7,900mW

Average power: 60mW

Slumber low-power mode: 49.9mW - 56.5mW

DEVSLP low-power mode: 4.9mW - 11.9mW

▪ Endurance

7

Up to 500 TBW

▪ Advanced Flash Management

Tiered caching architecture

Error-management system

TRIM command support

Dynamic and static wear leveling

Bad block management

Background garbage collection

▪ Dynamic Thermal Throttling

Performance may be throttled in order to avoid cases where the temperature

exceeds the product allowable temperature envelope

Three modes dependent on thermal conditions

▪ High Reliability

Mean time to failure (MTTF): Up to 1,752,000 hours

Uncorrectable bit error rate (UBER): 1 bit per 1016 bits read

Operational and non-operational shock: 1,500G, 0.5ms half sine

Operational vibration: 5gRMS,

10-2000

Hz

Non-operational vibration: 4.9gRMS,

7-800

Hz

Operational temperature

8

: 0˚C to 70˚C (32˚F to 158˚F)

Non-operational temperature and storage

8,9

: -55˚C to +85˚C (-67˚F to 185˚F)

5

Performance measured for 500GB product, using CrystalDiskMark (1000MB LBA range)

on SATA 6Gb/s host.

6

Power measured (all capacities) via MobileMark

2014 @ 3.3V on SATA 6Gb/s host

(drive

configured,

DIPM enabled, HIPM disabled)

7

2TB capacity using JEDEC client workload (JESD219).

8

Operational temperature is

defined

as ambient temperature around the SSD. It is not

measured from the on-board temperature sensor. It is important to note that on-board

temperature sensor readings are expected to be higher than ambient temperature

when the SSD is placed inside a system.

Introduction

WD Blue 3D NAND SATA SSD

User Manual

3

Advertising