Emulex Printer Server - Manual (Page 20)

14 Command Reference Guide
Node Commands
The length of node names is dependent on the protocol. Any
alphanumeric character may be used, along with: ‘$’, ‘-’, ‘_’, ‘.’.
• NetWare node names can have a maximum of 47 characters
• LAT node names can have a maximum of 16 characters
• TCP/IP node names can have a maximum of 63 characters
TCP/IP node names consist of a 1-16 character local node name and
a domain name of 1-47 characters. This TCP/IP full node name
always ends with a period (.).
A remote node must be specified by the full node name. A name on
the local network may be specified by the local node name alone if
the domain name for the local network has been set by the [Set
|Define |Change] Server Domain Name command.
Show Node
Show which nodes are known to the printer server.
>
Server>> [show |list] node [node_name] [gateway
|syslog |nfserver |npserver]
node_name Optional variable. Shows only the node whose
name you enter here.
gateway Shows all nodes designated as TCP/IP gateway
nodes. Gateway nodes allow communication
between segments on a network.
syslog Shows all nodes designated as TCP/IP syslog
nodes. Syslog nodes are designated to receive
events or errors.
nfserver Shows all the nodes designated as NetWare
Preferred File Server nodes.
npserver Shows all the nodes designated as NetWare
Remote Printer nodes.
Establish or Change TCP/IP Nodes
Establish or change a TCP/IP node.