Emulex Printer Server - Manual (Page 48)

42 Command Reference Guide
IP address for both the load and dump
functions.
ip_address Enter the IP address of the gateway node in
decimal dot notation. For example,
123.234.345.490. This address must be on the
same subnet as the printer server.
none Enter none to remove an existing IP address.
Although no IP address is chosen, the printer
server attempts the load or dump operation
without using a gateway. The printer server
attempts to use the IP address of the load or
dump host even if the host IP address is on a
different subnet than the printer server’s IP
address.
When the printer server loads its internal software over the network, it
checks to see if a gateway load_dump IP address has been set and uses
the set gateway to contact the node from which it will download its
operational software. In the same way, when the printer server performs
a crash dump upload, it checks to see if a gateway load_dump IP address
has been set and uses the set gateway to contact the node to which it will
send the dump of its internal memory.
Set Dump Host
Enable or disable the printer server’s ability to send a copy of its internal
memory to a specified dump host.
>
Server>> [set |define |change] server dump
[enabled |disabled]
enabled Default is enabled. When this command is
enabled, the printer server sends a file memory
image to a specified host before reinitializing
after a fatal error or upon execution of a Crash
300 command.
disabled When the command is disabled, no dump can
occur. Prior to a dump occurring, a preferred
dump node must be specified.
Define TCP/IP Dump Host