Electrolux EHD 60150 IAU - Manual (Page 21)

electrolux 21
Finally, the connecting cable is to be secured
with the mains cable cleat and the covering
closed by pressing firmly (lock into place).
Before switching on for the first time, any
protective foil or stickers must be removed
from the glass ceramic surface.
1
Once connected to the mains supply
check that all cooking zones are ready
for use by briefly switching each on in
turn at the maximum setting.
A duplicate rating label is supplied with
this unit. For easy identification of this
unit after installation, stick it to a readily
available surface adjacent to the cook-
top.
Sticking the seal in the rabbet
•
Clean the rabbet in the work surface.
• Stick the one-sided self-adhesive seal-
ing tape supplied onto the upper surface
of the rabbet along the edges of the cut-
out section.
– Cut the sealing tape into four pieces
relating to the length of the edges of
the rabbet.
– For the four corners of the rabbet the
ends of the sealing tapes must be cut
into mitres. Do not stick the ends over
one another.
– Stick the sealing tape flush into the
corner of the rabbet, so that no silicon
compound can get under the glass
ceramic when grouting.
– Don’t stretch the tapes when sticking
them on.