Mount your rt6600ax – Synology RT6600 AX6600 Wireless Tri-Band 2.5G / Gigabit Router User Manual
Page 10
10
Chapter 2: Hardware Setup
3
Connect wired client devices to your RT6600ax. Use network cables to connect devices to the LAN ports. The
corresponding LAN LED indicators should turn orange/green to indicate successful connection.
Mount Your RT6600ax
• Do not install the device in an unstable location, such as on an unsteady table or an inclined surface.
• Do not place another hub or object that generates heat on top of this unit.
• Please route all cables properly to prevent people from tripping over them.
• Ensure the air vents on the product are not blocked by other equipment or walls.
•
Only use the power cable included with the product. Using other power cables may result in damage or fire.
• Use 2 screws (not included) with the dimensions shown below.
• The screw head should project out from the wall at 7mm.