Hybridcare™ heat pump technology – Whirlpool 27 Inch Ventless Electric Dryer Use and Car Guide User Manual

Page 4

Advertising
background image

4

HybridCare™ HEAT PUMP TECHNOLOGY

A typical dryer uses large amounts of energy; this dryer consumes a fraction of the energy by recycling and reclaiming heat.

The HybridCare™ dryer is a ventless heat pump dryer that uses a refrigeration system to dry and recycle the same air.

The laundry is dried with low temperatures; therefore it may feel cooler than expected during and after the drying process.
The heat pump dryer’s heating phase is longer than in traditional dryers. If possible, do not open the dryer door during the

process as heat can escape from the drum and can make longer drying times.

HybridCare™ Heat Pump Unit

3

4

2

1

Heat Exchanger/Condenser is heating

up the air

Drying

Air blower is cooling air

Evaporator is cooling and discharging

condensation water

Benefits of HybridCare™ Heat Pump

• ENERGY: Regenerates energy to reduce overall energy

consumption.

• PERFORMANCE: Two available modes allow flexibility to

manage drying performance and energy savings.

• FABRIC CARE: Capability to use less heat than vented dryer.
• VENTLESS DESIGN: Allows installation in more locations

throughout the home.

New Sounds from HybridCare™ Heat Pump

• Dryer runs on a compressor like your refrigerator and you

may notice a hum from the compressor.

• The water from wet clothes is pumped out to your drain.

You may notice a gurgling sound occasionally.

Use Automatic Cycles for better fabric care and energy savings

Use the Automatic Cycles to provide the most energy savings and enhanced fabric care from the dryer. During Automatic

Cycles, drying air temperature, heat pump unit temperature, and moisture level are sensed in the load. This sensing occurs

throughout the drying cycle and the dryer shuts off when the load reaches the selected dryness. Use the NORMAL dryness level

to provide optimal energy savings.
With Timed Dry, the dryer runs the amount of time set and can result in shrinkage, wrinkling, and static due to over-drying. Use

Timed Dry for the occasional damp load that needs a little more drying time or when using the drying rack.

1

2

3

4

Advertising
This manual is related to the following products: