Whirlpool 27 Inch Ventless Electric Dryer Use and Car Guide - Manual (Page 5)

5
CONTROL PANEL AND FEATURES
NOTE: The control panel features a sensitive surface that responds to a light touch of your finger. To ensure your selections are
registered, touch the control panel with your finger tip, not your fingernail. When selecting a setting or option, simply touch its name.
2
3 2 1
6
4
5
4 7 5
POWER
Touch to turn the dryer on and off. Touch to stop/cancel
a cycle at any time.
WHAT TO DRY/HOW TO DRY
Once a “What to Dry” is selected, the dryer automatically
selects the recommended or last-used “How to Dry”
option, as well as the recommended/last-used modifiers.
Both the “How to Dry” and modifiers can be changed if
desired. See the “Cycle Guide” for details.
START/PAUSE
Touch and hold until LED counts down “3-2-1” and the
dryer starts; then let go to start a cycle, or touch once
while a cycle is in process to pause it.
MODIFIERS
Use to select available modifiers for your dryer. Not all
cycles and options are available on all models.
Temp
When using Timed Dry/Quick Cycle, you may select
a dry temperature based on the type of load you are
drying. Use the warmest setting that is safe for the
garments in the load. Follow garment label instructions.
NOTE: Automatic Cycles will give you up to four
temperatures to adjust, depending on the model and the
“What to Dry” or “How to Dry” selections that have been
made.
Dryness
You may adjust the Dryness on Automatic Cycles, if
desired.
NOTE: Dryness is for use with Automatic Cycles only.
More Dry\Less Dry Timed Dry Adjust
Touch MORE TIME or LESS TIME with the Timed Dry/
Quick cycle to increase or decrease the length of the
cycle.
OPTIONS
Use to select available options for your dryer. Not all cycles
and options are available on all models.
Wrinkle Shield™ Option
If you will be unable to remove a load immediately,
touch Wrinkle Shield™ to add up to 150 minutes of
periodic tumbling to help reduce wrinkling.
NOTE: If you open the dryer door prior to the end of the
Wrinkle Shield™ option, the dryer will go into standby.
You will need to touch Power to turn off or touch
Start/Pause to continue Wrinkle Shield™ option.
Steam Refresh (steam models only)
This cycle is best for reducing wrinkles and odors
from dry items. Cycle time will increase, depending
on number of items. This is an independent cycle that
cannot be combined with any other cycle.
Cycle Signal
Use this option to turn the signal indicating the end of
a drying cycle to low, medium, high, or off. The volume
you select here will also be applied to the Damp Dry
Signal.
NOTE: You may also turn off the tones that sound when
a feature, setting, or option is touched. Touch and hold
CYCLE SIGNAL for about three seconds to turn sounds
to low, medium, high, or off.
Damp Dry Signal
Touch to select the Damp Dry signal on or off. When
selected, a series of beeps will sound when the load
is damp, but not completely dry. This will allow you to
take clothes out of the load that do not need to dry
completely. This option is available on some cycles. The
Damp Dry signal is selected as a default for the Bulky
Items/Normal, Bulky Items/Wrinkle Control, and Bulky
Items/Heavy Duty, as a reminder to manually reposition
bulky loads midway through the cycle.
Control Lock
Use this option to lock the controls of the dryer
and avoid an accidental change in cycle options or
preferences during a drying cycle.
Touch and hold DAMP DRY SIGNAL (depending on the
model) for 3 seconds to lock or unlock the controls of
the dryer. During this time, the LED Display will count
down “3-2-1”. Once the controls are locked, the LED
Display will display “Loc.”
NOTE: The Control Lock function may be enabled
when recovering from a power failure. To unlock the
control, touch and hold DAMP DRY SIGNAL for at least
3 seconds.
1
2
3
4
5