EAW NT59 - Manual (Page 6)

Section 2 Unpacking
2 . 1 C o n t e n t s
Qty Item
1 NT Series Product
1 Power Cable (dependent on product's ac mains rating)
115 V - Neutrik PowerCon to Nema 15R plug
230 V - Neutrik PowerCon to male Schuko plug
1 Owner's Manual (this document)
1 EAW Loudspeaker Owner's Manual
1 Warranty Card
Section 3 Quick Start
If you are in a hurry or are knowledgeable about using powered loudspeakers, these Quick
Start instructions provide the details particular to the NT Series loudspeakers. For the
instructions in this section, refer to the accompanying Figures.
3 . 1 I n i t i a l C o n t r o l S e t t i n g s
Use these nominal settings for the rear panel switches.
Full-Range with no subwoofer
HPF 55 Hz
Mode Normal
Full-Range with subwoofer
HPF 110 Hz
Mode Normal
Subwoofer
Gain 0 dB
Polarity Normal
WARNING: Before connecting an NT loudspeaker to the ac
mains supply, completely turn down the input signal to
the loudspeaker using the signal source's output level
(master volume control or other output level control). If
not, there could be excessive and possibly damaging sound
levels from the loudspeaker when energized.
3 . 2 A u d i o C o n n e c t i o n
Connect the output from your line-level signal source to
the XLR-3F Input connector on the rear panel. This is an
electronically balanced input.
3 . 3 A C M a i n s C o n n e c t i o n
Connect the supplied ac mains cord to the Neutrik
PowerCon socket on the rear of the loudspeaker. Connect
the other end to an ac mains supply receptacle, nominal 115
V 60 Hz or 230 V 50 Hz as labeled on the loudspeaker. If
necessary, have a qualified electrician change the cable plug
as required for compatibility with the local ac mains
receptacle.
2