Eaton Electrical 0800-2000 - Manual (Page 11)

To scroll down through menus or menu items in the same level:
Press the
t button on the right side of the display.
To scroll up through menus or menu items in the same level:
Press the
s button. You can also look at the bottom line of the display, which includes the words “Top”
and “ESC.” The button under the word “Top” will take you to the top of the list of items in the menu
level.
Example: When you switch to the menu display, the display shows the top item in the top level (1,
Enter password). To scroll down to menu 2 (System Status), press the
t button. Press this
button again to scroll down to menu 3 (System Status Info), and so forth. To scroll back up to
menu 1, press
s twice or press the button below “Top.”
To display the items in a menu or submenu:
Go to the display that represents the menu or submenu, and press the
¿ button.
Example: The interface starts at the top item in the top level (1, Enter password). If you scroll down to
menu 2, the display shows “System Status.” To display the items in the System Status menu,
press
¿. You can then scroll down and back up through the items in this menu.
To move back up a menu level:
Notice that the bottom line of the display shows “Top” and “ESC.” If you press the button under “ESC”
(the right button below the display), the display goes back to the next higher menu level.
502 Displaying a Parameter by Entering the Parameter Number
For service purposes, parameters are also assigned sequential numbers (1-337). If you know a parameter number
and want to go directly to that parameter, you can use menu 7 in the top level menus (Parameters) to display the
parameter. Simply follow these steps:
1. Scroll down to menu 7, and press
¿. The third line of the display will change to “parameter = 000,” and the
bottom line of the display will change to “
<– –> ESC” to show the functions of the three buttons below
the display.
2. Use the
<– and –> buttons to scroll through the digits to the left and right, and use the s and t buttons to
increase or decrease the value of each digit. When the three digits show the number of the parameter you wish
to display, press
¿.
Example: To display parameter 32, you need to change the three digits (000) to “032.” Since you do not
need to change the first digit, press the button below –
> to move the cursor to the second digit.
Then, press
s three times to increase the second digit to “3.” Next, move to the third digit, and
press
s twice to increase this digit to “2.” Now, the display shows “parameter = 032.” Press ¿.
The parameter’s short name and value will appear on the third line of the display.
10
7
Enter A Parameter
parameter # 000
<– –> ESC