Eaton Electrical 0800-2000 - Manual (Page 28)

27
1100 Notices
2-3 kVA Soft-wired (Plug-in) and 50 Hz Models:
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B device
pursuant to part 15 of FCC rules. These limits are designed to provide reasonable protection against
harmful interference when this equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This Class B interference causing equipment meets all requirements of the Canadian Interference
Causing Equipment Regulations ICES-003.
Cet appareil numerique de la Classe B respecte toutes les exigences du Reglement sur le materiel
brouileur du Canada.
4.5-7.5 kVA Models and Hard-wired 60 Hz 2-3 kVA Models:
Note: This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable protection against
harmful interference when this equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his/her own expense.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This Class A interference causing equipment meets all requirements of the Canadian Interference
Causing Equipment Regulations ICES-003.
Cet appareil numerique de la Classe A respecte toutes les exigences du Reglement sur le materiel
brouileur du Canada.