Eaton Electrical 0800-2000 - Manual (Page 9)

8
b. Press the
t button twice until the display shows “3 System Status Info.”
c. Press
¿ once. The display will now show “3
1 Unit Time.”
d. Press
¿. A cursor will appear in the time
shown.
e. Notice that the bottom line of the display has
changed to “
<– –> ESC” to show you that
you can now use the bottom three buttons to
move left, move right, or escape. Use these buttons to move the cursor to each digit you need to
change, and use the
s and t buttons to increase or decrease each digit. Use 24-hour time (add 12 to
the hour if the time is after noon). Press
¿ to save the setting.
Example: If the time shown is 12:07, and the actual time is 3:15 PM, enter 15:15. Start by pressing
the button below –
> to move to the “2,” and press s three times to increase this to “5.”
The third line of the display is now “Time 15:07.” Press the button below –
> to move to the
third digit (after the :), and press
s once to increase this to “1.” Next, press the button
below –
> again to move to the next digit, and press t twice to decrease this to “5.” When
you have finished, press
¿ to save the setting.
f. Now, press
t once to scroll down to “Unit
Date.”
g. Press
¿. A cursor will appear in the line
“Date 01/01”. (This line may show a dif-
ferent date.)
h. As you did with the time, use the buttons
below
<– and –> to move to the left and
right, and use the
s and t buttons to increase or decrease the value of each digit in the date.
Example: If the date now shown is 01/01, and you would like to change it to 07/06/98, you would use –
>
to move to the second digit and press
s six times to increase it from “1” to “7.” Then, you
would move to the fourth digit and change that to “6.” Since the other digits match the date you
want to enter, you do not need to change the other digits.
i. When the display shows the correct date, press
¿, and the FERRUPS date will change.
j. Now, press
t once to scroll down to “Set
Unit Year.” Press
¿. A cursor will appear in
the year. As you did with the time and date,
use the buttons below
<– and –> to move to
the left and right, and use the
s and t but-
tons to increase or decrease the value of
each digit in the year.
k. When the display shows the correct date,
press
¿, and the FERRUPS year will change.
3 1
Unit Time
time 01:15
<– –> ESC
3 2
Unit Date
date 01/01
<– –> ESC
3 3
Unit Year
year 1998
<– –> ESC