Rx − 8564 lc – Epson RX-8564LC User Manual
Page 20
RX
−
8564
LC
Page
−
17
ETM12E-01
13.1.9. CLKOUT output register (Reg
-
0D
[h])
Address
[h]
Function
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
0D
CLKOUT frequency
FE
Ч
Ч
Ч
Ч
Ч
FD1
FD0
•
This register is used to control clock output via the CLKOUT output pin.
•
This register is valid only when the CLKOE input pin is at high level, at which time clock output is enabled or
disabled (stopped) depending on the settings in this register.
∗
When the CLKOE input pin is at low level, CLKOUT is at low level regardless of the settings in this register.
1) FE bit
(
Frequency output
Enable
)
When this register is valid (when CLKOE is at high level), it is used to control the CLKOUT pin's output
status.
When the FE bit value is "1", the CLKOUT pin is in output mode. The content being output at that time is
the frequency specified via the FD1 and FD0 bit.
When the FE bit value is "0", the CLKOUT pin is output STOP mode (= low level).
2) FD1,
FD0 bits
A combination of the FD1 and
FD0 bits is used to select the frequency to be output.
3) CLKOUT output based on various settings
CLKOE pin
input
FE
bit
FD1
bit
FD0
bit
CLKOUT pin
output
0
0
32768
Hz
Output
(
C-MOS
)
0
1
1024
Hz
Output
(
C-MOS
)
1
0
32
Hz
Output
(
C-MOS
)
1
1
1
1
Hz
Output
(
C-MOS
)
"
H
"
0
Χ
Χ
OFF
(
"
L
"
)
1
Χ
Χ
OFF
(
"
L
"
)
"
L
"
0
Χ
Χ
OFF
(
"
L
"
)
Χ
: don't care
∗
During initial power-on (from 0 V), "1" is set to the FE bit by the power-on reset function, and the FD1
and FD0 bits are reset to zero.
Consequently, 32.768
kHz output can be obtained from the CLKOUT output pin by setting the CLKOE
input pin to high level.
Note) Re: CLKOUT output operation when STOP bit value is "1"
Note with caution that when the STOP bit value is
"1", output via CLKOUT may be stopped, depending on
the selected frequency.
(1) When 32.768
kHz output has been selected, output continues at 32.768
kHz.
(2) When any other frequency has been set (1024Hz,
32Hz,
or 1Hz), CLKOUT output is stopped.