Electrolux D98000VF - Manual (Page 12)

12
THE HOB
Do not use the appliance if the ceramic
glass is damaged. If a fault or crack
becomes visible, disconnect the appliance
immediately from the electricity supply and
contact your local Service Force Centre.
USING THE HOB
•
The hob must be switched on ( ) before setting
any cooking function or programme.
•
For single hotplates press the increase or
decrease control to vary the heat setting.
The highest number represents the hottest
setting and the lowest number represents the
coolest setting. Choose a setting appropriate to
the quantity and type of food to be cooked.
•
To operate the dual and triple hotplates press the
increase or decrease control to vary the heat
setting and then press the hotplate icon to
activate the additional heat zones. When a zone
is activated a neon illuminates next to the
hotplate setting. To deactivate a zone press the
hotplate icon again.
•
To turn off a hob element press the increase
and decrease controls together.
AUTOMATIC WARM UP
All cooking zones are equipped with an automatic
warm up function. The cooking zone switches to full
power for a certain amount of time and then
automatically switches back to the heat setting set.
Press and scroll through the heat settings to 9
then press again 'A' will show in the display. An
audible signal will sound. Now press to the
setting you require. The hob will show 'A' in the
display until the Automatic warm up programme has
finished then refers to the setting set.
USING THE STOP + GO FUNCTION
The stop + go function switches all cooking zones
that are switched on to the keep warm setting and
then back to the heat setting that was previously set.
This function can be used to briefly interrupt and then
continue the cooking process.
To switch on press the hob display will show
keep warm .
To switch off press the display will revert to the
heat setting that was previously set.
USING THE HOB TIMER
All cooking zones can use each one of the two timer
functions at the same time.
If a cooking zone is switched off, the timer function
set is also switched off.
Function Condition Outcome after the
time has elapsed
Automatic
cut-out a heat setting is
set acoustic signal 00
flashes
Cooking zone
switches off
Countdown
timer cooking zones
not in use acoustic signal 00
flashes