Electrolux D98000VF - Manual (Page 17)

17
SECOND OVEN CONVENTIONAL COOKING
The second oven is the smaller of the two ovens. It is
heated by elements in the top and bottom of the oven.
It is designed for cooking smaller quantities of food. It
gives especially good results if used to cook fruit
cakes, sweet and savoury flans or quiche.
USING SECOND OVEN CONVENTIONAL
COOKING
•
The oven must be switched on ( ) before
setting any cooking function or programme.
•
Press the Oven Cavity selector until the
second oven cavity indicator is illuminated.
•
Press the Function selector until the
Conventional Cooking neon is illuminated.
•
Wait 5 seconds until your choice is confirmed.
The temperature will automatically set to 200°C.
•
If you wish to alter the set temperature, you may
do so by pressing or
until the required
temperature setting is reached.
•
To switch off a function simply press the Function
selector once. The function neon will go out and
the display will return to the time of day.
THINGS TO NOTE
•
The interior-lighting will illuminate.
•
The heat indicator neons will flash until the oven
has reached the desired temperature and then
stop, an audible signal will sound. When the
oven has been switched off the bars that are still
lit indicate the remaining residual heat in the
oven.
•
If it is necessary to reach the required
temperature in a shorter time, the Fast Heat
Function can be used. See Fast Heat Function
section.
•
The cooling fan for the controls may operate after
a time.
•
If an automatic programme has been set, the
interior-lighting does not come on until cooking
begins.
•
Some internal noise may be heard during
operation. This is quite normal.
Do not place dishes, tins or baking trays
directly onto the oven base as it becomes
very hot and damage may occur.
TO FIT THE SECOND OVEN SHELF
The shelf should be fitted with the straight rods
uppermost on the frame and the forms towards the
back of the oven. To remove a shelf slide the shelf
towards you until the shelf stop is reached. Tilt shelf
up at the front to that the stops clear the side
supports. Lift shelf clear. To install a shelf, reverse
the above steps. Each shelf position has an upper
and lower support wire, ensure the shelf is placed
between these two support wires.