Upholstery and stair cleaning, How to maintain, Empty the recovery tank – Eureka 2590 User Manual
Page 16: Clean suction cover
16
ENGLISH
Upholstery and Stair Cleaning
(continued)
Step 4: Place the Upholstery Nozzle at the top of the cleaning area.
Step 5: Pull up and hold the solution release trigger and pull the nozzle
backward at a moderate pace for no more than five seconds to
avoid over soaking.
Step 6: Release the trigger at the end of the stroke.
Step 7: Lift nozzle and start again at the top. Apply one to three spraying
strokes. Avoid over-soaking the area.
Note: As the nozzle moves over the surface, the cleaning solution
sprays onto the surface. At the same time the nozzle picks up
the dirty water and places it in the recovery tank.
Step 8: Move the nozzle over the surface several more times without
engaging the trigger. This removes excess water and helps the
surface dry faster.
Step 9: Adjust shampoo control to rinse and repeat steps 5-8 for a clean
water rinse.
Step 10: Press release button on top of hose to release attachment.
Step 11: After using attachment make sure hose inlet cover
●
H
is fully
closed.
Step 12: Clean upholstery brush attachment after use. Press attachment
release to remove from hose, pull suction cover open (Fig. 9),
rinse under warm running water. Replace on hose or store in
caddy.
HOW TO MAINTAIN
Before storing the extractor for long periods of time, it is a good
idea to set the shampoo control on rinse and push the spray button
for 10 seconds. This flushes the shampoo residue from the pump.
Place cleaner on a surface where water can easily be cleaned up. If
any attachments have been used clear hose line in same way.
Empty the Recovery Tank
See page 12 for instructions.
Clean Suction Cover
CAUTION: Turn off the power switch and unplug the electrical cord
before cleaning.
Step 1: Slide the suction cover release tabs
●
L
up on each side of the
suction cover
●
M
(Fig. 10).
Step 2: Remove the suction cover and clean the area of dirt and lint.
Step 3: Replace the suction cover by sliding the tabs on top of the
suction cover into the top slots on the hood.
FIG. 9
FIG. 10
●
L
●
L
●
M