Hypertec FastPrint Multiprotocol Ethernet/Fast Ethernet Print Server Hardware - Manual (Page 14)

6 Index
4. Connect the HyperNet Fastprint to the network, using the RJ-45
(10Base-T/100Base-TX) connector on the print server’s side panel.
5. While each printer is powered off, connect its tested and confirmed
port to a like printer port of the HyperNet Fastprint. If you are
connecting fewer than three printers, then keep in mind that parallel-
port connections are preferred for high-performance printers.
6. Switch on each connected printer.
7. Plug the DC power adapter’s DC output plug into the DC 12V power
socket on the side panel of the HyperNet Fastprint.
8. Plug the power adapter into an electric service outlet. This will supply
power to the HyperNet Fastprint, as it has no external power switch.
The Power/Tx LED on the HyperNet Fastprint’s front panel should
light steady green, and the HyperNet Fastprint’s self-test will proceed.
Power On Self-Test
When the HyperNet Fastprint is powered on, it automatically performs a self-
test on each of its major components. The final result of the self-test is
signaled by the state of the LPT1, LPT2, and COM LED indicators following
the self-test. Preliminary to the actual component tests, the three LED
indicators are tested to confirm their steady and flashing operation.
Immediately after power-up, all five of the LED’s should show steady green
for several seconds. Then the LPT1, LPT2, and COM LEDs should flash on