Hypertec FastPrint Multiprotocol Ethernet/Fast Ethernet Print Server Hardware - Manual (Page 16)

8 Index
To mount the HyperNet Fastprint with the front panel facing up (and the
printer port connectors facing down), set the two mounting screws at the
lower-left and upper-right corners of a rectangle as shown below (actual size):
110 mm
4
5 /
16
in
70 mm
2
3
/
4
in
When setting the screws into the wall or partition, leave about 3 mm ( 1 / 8 in)
between the head of each screw and the wall surface. Then place the
HyperNet Fastprint so that the mounting sockets on the bottom of its case fit
over the two screws. Press the case gently toward the wall and slide the case