HP 4100TN - Manual (Page 216)

214 Appendix B - Control panel menus EN
UNIT OF
MEASURE=INCHES
(110V printers)
or
MILLIMETERS
(220V printers)
INCHES
MILLIMETERS
This item appears only when
CONFIGURE
CUSTOM PAPER=YES
. Select the unit of
measurement for the custom paper size.
X DIMENSION=
8.50 INCHES
(110V printers)
or
216 MILLIMETERS
(220V printers)
For supported paper
sizes, see
“Supported sizes
and weights of
paper” on page 189. This item appears only when
CONFIGURE
CUSTOM PAPER=YES
. Use -V ALUE + and
S ELECT to select the dimension to be fed
into the printer (short edge) for custom
paper size.
Y DIMENSION=
14.00 INCHES
(110V printers)
or
356 MILLIMETERS
(220V printers)
For supported paper
sizes, see
“Supported sizes
and weights of
paper” on page 189. This item appears only when
CONFIGURE
CUSTOM PAPER=YES
. Use -V ALUE + and
S ELECT to select the other dimension (long
edge) for custom paper size.
ORIENTATION=
PORTRAIT
PORTRAIT
LANDSCAPE
Determine the default orientation of print on
the page.
Note
It is best to set the page orientation from the
printer driver or software application.
(Driver and software settings override
control panel settings.)
FORM LENGTH=
60 LINES
(110V printers)
or
64 LINES
(220V printers)
5
to
128
Sets vertical spacing from 5 to 128 lines for
default paper size. Press
-V ALUE + once to
change the setting by increments of 1, or
hold down
-V ALUE + to scroll by increments
of 10.
PCL FONT SOURCE=
INTERNAL
INTERNAL
SOFT
SLOT 1, 2,
or
3
INTERNAL
: Internal fonts.
SOFT
: Permanent soft fonts.
SLOT 1, 2,
or
3
: Fonts stored in one of
the three DIMM slots.
Note
It is best to set the font source from the
printer driver or software application.
(Driver and software settings override
control panel settings.)
Printing Menu (continued)
Item Values Explanation