HP 6200 User Manual
Page 109
4.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
You must disconnect the power cord and wait approximately 30 seconds for the
power to drain before adding or removing memory modules. Regardless of the power-on state,
voltage is always supplied to the memory modules as long as the computer is plugged into an
active AC outlet. Adding or removing memory modules while voltage is present may cause
irreparable damage to the memory modules or system board.
5.
If the computer is on a stand, remove the computer from the stand.
6.
Remove the computer access panel.
WARNING!
To reduce risk of personal injury from hot surfaces, allow the internal system
components to cool before touching.
7.
Rotate up the internal drive bay housing to access the memory module sockets on the system
board.
Figure 4-9
Rotating the Drive Cage Up
ENWW
Installing Additional Memory 101